By now you should have an idea on how this binding technique works. This time we try to bind two rectangular figures with rounded corners using 2 inside curves.  Figure 01  Figure 02 Figure 3 illustrates the map of this interface. The design uses 2 inside curves to bind the 2 rectangular figures. Figure 4 shows the position of the circular selection used to cut and create one of the curves. I positioned the left end of the lower curve near the lower rounded edge to create the illusion that the rounded corner of the first rectangular figure extends to the next rectangle.  Figure 03  Figure 04 Figure 5 illustrates a bad curve(gee), the cut came off a few pixels short from the the rounded corner of one of the rectangular figure. Guess I need more practice :P  Figure 05
|
